CAUTION:
Please read the instruction sheet carefully before use
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
- This device may not cause harmful
interference.
- This device must accept any
interference received, including
interference that may cause
undesired operation.
- Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.This equipment has
been tested and found to comply
with the limits for a Class B digital
device, pursuant to part 15 of the
FCC Rules. These limits are designed
to provide reasonable protection
against harmful interference in a
residential installation.
This equipment can radiate radio
frequency signals and, if not installed
and used according to the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a
particular installation. If this equipment
does cause harmful interference to
radio or television reception, which
can be determined by turning the
equipment o and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an
outlet on a circuit dierent from that
to which the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
To satisfy FCC RF exposure
requirements, a separation distance of
20 cm or more should be maintained
between the antenna of this device
and persons during device operation.
To enable Power Saving Mode: In standby or charging state, press and hold
the docking button and the LiDAR sensor for 20s. All the indicator lights
will turn o.
To disable Power Saving Mode: press and hold the power button to restart
the machine.
CLASS 1 LASER PRODUCT
INVISIBLE LASER RADIATION
This device complies with DHHS Radiation Rules, 21CFR Chapter 1, SubchapterJ.
1.
2.
To reduce the risk of electric shock, the docking station of the appliance has a
polarized plug (one blade is wider than the other). This plug will fit in a polarized
outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do not change the plug
in any way.
FCC Compliance Statement
IMPORTANT SAFEGUARDS
6 Eureka Customer Service HELPLINE 1-800-282-2886
To Next Page
Loading...
