Eureka NEW430BL - Product Installation

08
Installation
Insert the end of the handle into the
port of the main unit along the
vertical direction until there is a click,
which indicates the installation is
successful;
Removal
Insert a screwdriver or other tools
into the hole, and pull out the handle
upward.
Charging Battery
Insert the charging end of the charger into the rear port of
the charging dock, and connect the plug to a 100V-240V
power.
Put the machine upright into the charging/docking station,
and make sure that the bottom of the body completely falls
into the charging base. At this moment, a voice will prompt
“start charging”, and the indicator light flashes.
It takes about 3-4 hours to fully charge the machine.When
the battery is fully charged, the indicator will turn o and the
machine will automatically power o.
1.
2.
3.
PRODUCT INSTALLATION
Insert Insert
WARNING
For the purposes of recharging the battery,
only use the detachable supply unit provided
with this appliance.
ATTENTION
Charge the product before the first use.
Handle Installation and Removal