15
PROBLEM SOLVING
Make sure vacuum is turned o and power cord is unplugged.
Problem Possible cause Solutiom
Abnormal noise when machine is on
Floor brush doesn't have water
The roll brush isn't spinning
The nozzle is blocked Clean up obstacles in the nozzle
The clean water tank is empty Add water to the clean water tank
The clean water tank is empty Add water to the clean water tank
The clean water tank is not installed in
place
Reinstall the clean water tank
The clean water tank is not installed in
place
Reinstall the clean water tank
The roll brush is entangled with hair and
other objects
Clean the roll brush
The dirty water tank is full Clean uup the dirty water tank
Low battery Recharge the machine
The pipe is blocked Clean up the pipe under the waste water tank
NOTICE: Thermal cut-o
This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum suddenly shuts o,
proceed as follows: 1) Push the power switch to o and unplug the vacuum. 2) Check the vacuum for a possible source of overheating
such as a full dirty water tank, blocked intake passage or clogged filter. If these conditions are found,fix them and wait at least 30
minutes before attempting to use the vacuum. 3) After the 30 minute period, plug the vacuum back in and turn on the switch.
To Next Page
Loading...