To Next PageTo Next PageWhat to do if my Euro-Pro EP8020 Iron is leaking water?
If your Euro-Pro Iron is leaking water from the soleplate, it could be due to: 1. The soleplate temperature being too low for steam ironing. Turn the temperature dial to the marks between 2 and 3 dots. 2. The generator not being fully heated. Wait for the generator to fully heat up before using.
How to fix a Euro-Pro EP8020 Iron soleplate that won't heat up?
If the soleplate of your Euro-Pro Iron remains cold, check the following: 1. Ensure the Iron is switched ON by turning the Iron ON/OFF Rocker Switch to the “ON” position. 2. Verify that the temperature dial is not set at “Minimum”. Adjust the temperature dial to the appropriate setting.
Why is the steam from my Euro-Pro Iron dirty or yellow?
If the steam coming out of your Euro-Pro Iron is dirty or yellow, it could be caused by: 1. Residue in the water tank. Clean the steam generator as per the provided instructions. 2. Not using demineralized/distilled water. After cleaning the tank, use only demineralized/distilled water.
Details the polarized plug safety feature and correct usage for electrical outlets.
Guidance on avoiding circuit overload and using appropriate extension cords.
Explains how to check water hardness and recommends water types for optimal performance.
Advice to avoid leaving the hot iron idle to prolong the appliance's lifespan.
Step-by-step guide for performing dry ironing with the steam generator iron.
Detailed instructions for using the steam function, including setup and operation.
How to activate and deactivate the continuous steam lock-on feature for steady steam supply.
Procedure for safely releasing residual steam from the steam generator.
Step-by-step instructions for filling or refilling the removable water tank.
Guidance on when to refill the water tank or steam generator for optimal performance.
Table correlating fabrics with recommended temperature ranges and steam usage.
Advice on using steam intermittently for better pressing results and garment care.
Tips for pressing challenging natural fibers, suggesting damp ironing or pre-spraying.
Explains how iron temperature settings dictate dry or humid steam output.
Highlights flexibility in choosing steam type for optimal pressing results.
Proper procedures for storing the ironing system safely when not in use.
Detailed steps for cleaning the iron's soleplate and exterior casing.
Guidance on rinsing the steam generator and base tank for optimal performance.
Details the one-year limited warranty, exclusions, and purchaser responsibilities.
General