Euro-Pro mini Shark EP031

To Next Page

Hand Vacuum

IMPORTANT SAFETY INSTRUCTIONS

When using your Hand Vacuum, basic safety precautions should always be

observed, including the following:

To reduce the risk of fire, electric shock, or

injury:

• Do not leave the hand vacuum plugged in

when unattended. Unplug the electrical cord

when not in use and before servicing.

• Do not allow to be used as a toy. Close

attention is necessary when used by or near

children, pets or plants.

• Use only as described in this manual. Use

only manufacturer’s recommended

accessories.

• Do not pull cord, use cord as a handle, close

a door on cord, or pull cord around sharp

edges or corners. Keep cord away from

heated surfaces.

•Use only extension cords UL-rated or cUL at

15 amperes, extension cords rated for less

amperage may overheat. Care should be

taken to arrange the cord so that the cord

cannot be pulled or tripped over.

• Turn off all controls as applicable before

unplugging from electrical outlet.

• Do not unplug by pulling on cord. To unplug,

grasp the plug, not the cord.

• Do not handle plug or hand vacuum with wet

hands or operate without shoes.

• Do not put any objects into openings. Do not

use with any opening blocked. Keep free of

dust, lint, hair and anything else that may

reduce air flow.

• Store your appliance indoors in a cool, dry

area.

• Keep your work area well lit.

• Do not immerse the hand vacuum into water

or other liquids.

• Keep end of hose, wands and other openings

away from your face and body.

• Use only on dry surfaces.

• Using improper voltage may result in damage

to the motor and possible injury to the user.

Correct voltage is listed on rating label.

1. Read all instructions before using your

hand vacuum.

2. Use the system only for its intended use.

3. To protect against a risk of electric shock,

do not immerse any part of the system in

water or other liquids.

4. Never yank cord to disconnect from

outlet; instead, grasp plug and pull to

disconnect.

5. Do not allow cord to touch hot surfaces.

6. Do not run appliance over cord.

7. Do not operate the system with a damaged

cord or plug, or if the appliance or any other

part of the system has been dropped or

damaged. To avoid the risk of electric

shock, do not disassemble or attempt to

repair the hand vacuum. Return the

system to EURO-PRO Corporation (see

warranty) for examination and repair.

Incorrect re-assembly or repair can cause a

risk of electrical shock or injury to persons

when the unit is used.

8. Close supervision is necessary for any

appliance being used by or near children.

Do not leave the system unattended while

connected.

9. Keep hair, loose clothing, fingers and all

parts of body away from opening and

moving parts.

10. Do not use to pick up flammable or

combustible liquids such as gasoline or use

in areas where they may be present.

11. Do not pick up anything that is burning or

smoking such as cigarettes, matches or hot

ashes.

12. Use extra care when cleaning on stairs.

13. Do not use the hand vacuum without the

dust cup filter in place.

14. This appliance is intended only for

household use. Follow all user instructions

in this manual.

OWNER’S MANUAL

Model EP031

120V~, 60Hz.

400 Watts, 3.2 Amps

SAVE THESE INSTRUCTIONS

For Household Use Only

For information or assistance:

USA: EURO-PRO Corporation

178 West Service Rd.

Champlain, NY 12919

Tel: 1 866 98SHARK (1 866 987-4275)

www.sharkvac.com

Rev. 02/03

WARNING: To reduce the risk of electric shock, this appliance has a

polarized plug (one blade is wider than the other). This plug will fit in a

polarized outlet only one way. If the plug does not fit fully in the outlet,

reverse the plug. If it still does not fit, contact a qualified electrician to install

the proper outlet. Do not modify the plug in any way.

Need help?

Do you have a question about the Euro-Pro mini Shark EP031 and is the answer not in the manual?

Summary

Getting to Know Your Hand Vacuum

Technical Specifications

Details voltage, frequency, wattage, and amperage of the hand vacuum.

Operating Instructions

Assembling the Hand Vacuum

Steps for attaching the dust cup, crevice tool, and upholstery brush to the hand vacuum.

How to Operate Your Hand Vacuum

Instructions on holding and operating the hand vacuum using the power button.

Operating Instructions (Continued)

Cleaning & Changing the Dust Cup Filter

Procedure for removing, cleaning, and re-installing the dust cup filter.

Replacement Filters

For Technical Support

Contact information for technical support and warranty assistance.

Summary

Getting to Know Your Hand Vacuum

Technical Specifications

Details voltage, frequency, wattage, and amperage of the hand vacuum.

Operating Instructions

Assembling the Hand Vacuum

Steps for attaching the dust cup, crevice tool, and upholstery brush to the hand vacuum.

How to Operate Your Hand Vacuum

Instructions on holding and operating the hand vacuum using the power button.

Operating Instructions (Continued)

Cleaning & Changing the Dust Cup Filter

Procedure for removing, cleaning, and re-installing the dust cup filter.

Replacement Filters

For Technical Support

Contact information for technical support and warranty assistance.

The device is a mini Shark Hand Vacuum, model EP031, designed for household use. It operates on 120V~, 60Hz, with a power consumption of 400 Watts and 3.2 Amps.

Function Description:

The mini Shark Hand Vacuum is a compact and portable cleaning appliance intended for quick clean-ups around the house. Its primary function is to vacuum dry surfaces, picking up dust, lint, hair, and other small debris. The device is equipped with various accessories to enhance its versatility for different cleaning tasks.

Important Technical Specifications:

Model: EP031
Voltage: 120V~
Frequency: 60Hz
Power: 400 Watts, 3.2 Amps
Filter Type: Washable Dust Cup Filter (SKU# XSB031)
Plug Type: Polarized plug (one blade wider than the other)

Usage Features:

The hand vacuum is designed for ease of use and maneuverability.

Assembly: To assemble, the dust cup (container) is attached to the main body after ensuring the dust cup filter is in place. Accessories like the crevice tool or upholstery brush can be directly pushed into the suction hole. For extended reach or specialized cleaning, the flexible hose can be attached to the suction hole, and then the desired accessory can be connected to the other end of the hose.
Operation: To operate, the user holds the hand vacuum firmly by the handle and pushes the On/Off Power Switch to the "On" position. The device is powerful, so a firm grip is recommended to prevent it from slipping and causing injury.
Accessories: The hand vacuum comes with several accessories to suit different cleaning needs:
- Upholstery Brush: Ideal for cleaning fabric surfaces.
- Crevice Tool: Designed for reaching into narrow spaces and corners.
- Flexible Hose: Provides extended reach and flexibility for cleaning awkward areas when combined with other accessories.
Safety Precautions: The manual emphasizes several safety instructions to ensure safe operation:
- Always read all instructions before use.
- Do not immerse any part of the system in water or other liquids to avoid electric shock.
- Always grasp the plug, not the cord, to disconnect from the outlet.
- Keep the cord away from hot surfaces and do not run the appliance over the cord.
- Do not operate the system with a damaged cord, plug, or if any part has been dropped or damaged.
- Do not disassemble or attempt to repair the hand vacuum; return it to EURO-PRO Corporation for examination and repair.
- Close supervision is necessary when used by or near children, pets, or plants.
- Keep hair, loose clothing, fingers, and all body parts away from openings and moving parts.
- Do not use to pick up flammable or combustible liquids, or anything burning or smoking (e.g., cigarettes, matches, hot ashes).
- Use extra care when cleaning on stairs.
- Do not use the hand vacuum without the dust cup filter in place.
- Unplug the electrical cord when not in use and before servicing.
- Do not put any objects into openings or use with any opening blocked; keep free of dust, lint, hair, and anything else that may reduce airflow.
- Store the appliance indoors in a cool, dry area.
- Use only on dry surfaces.
- The polarized plug must be inserted correctly into a polarized outlet; if it doesn't fit, reverse the plug. If it still doesn't fit, contact a qualified electrician. Do not modify the plug.

Maintenance Features:

Regular maintenance is crucial for the optimal performance and longevity of the hand vacuum.

Dust Cup and Filter Cleaning:
- Always unplug the unit from the electrical outlet before opening the dust cup.
- After each use, the dust cup filter should be removed and emptied.
- To open the dust cup, push the release button and detach the dust cup (container).
- Remove the dust cup filter.
- Empty the dust from the dust cup (container).
- Rinse the dust cup filter in cold water and allow it to dry completely for 24 hours before re-installing it.
- Once completely dry, carefully replace the dust cup filter back into the dust cup (container) and then attach the dust cup (container) to the hand vacuum.
- Important: Do NOT use the hand vacuum without the dust cup filter in place. The suction hole must be open and free of obstructions at all times; otherwise, the motor may overheat and be damaged.
Filter Replacement: The dust cup filter is washable, but it should be replaced every three (3) months to ensure peak performance. Replacement filters (SKU# XSB031) can be ordered by calling 1-866-98SHARK or visiting www.sharkvac.com.
Troubleshooting: The manual provides a troubleshooting guide for common issues:
- Hand vacuum will not operate: Check if the power cord is firmly plugged in, if there's power in the wall outlet (check fuse/breaker), or if it needs servicing.
- Hand vacuum will not pick-up or suction power is weak: This could be due to a full dust cup, a clogged unit, or a dirty/worn dust cup filter. Solutions include emptying the dust cup, checking for and removing obstructions in the air duct, and cleaning or replacing the dust cup filter.
- Dust escaping from hand vacuum: Possible causes are a full dust cup, an incorrectly installed dust cup filter, or a puncture/hole in the dust cup filter. Solutions involve emptying the dust cup, reviewing filter installation instructions, and replacing the dust cup filter if damaged.
- Hand vacuum hose or brushes will not pick-up: This indicates a clogged hose or brushes, or a full dust cup. Solutions include removing obstructions from the hose/brushes and emptying/cleaning the dust cup.

The device is covered by a one (1) year limited warranty from EURO-PRO Corporation, covering defects in material and workmanship for normal household use. Non-durable parts like dust cups, filters, and brushes are excluded from the warranty.