E-Drive sur CF80 en Anglais UCF-000R001-GB F.M:08/14 p: 36/41
The oven does
not heat
anymore
For a gas or fuel oven
Check the proper operation of the safety thermostat (oven)
Check the proper operation of the chimney safety thermostat.
The safety device governing the extraction of fumes MUST NOT be bypassed
Use the reset button located on the burner (above the oven).
If after 2 or 3 attempts, the burner does not restart, check the gas supply.
Fault in the supply
of steam
To change the quantity of steam, increase/decrease the steam duration with the regulator.
Check the programmed injection time.
Does the water supply well provided and with a sufficient outflow ?
Does the solenoid valve function normally ?
The water pressure must comply with the minimum 3 bars necessary and the
maximum 5 bars. On networks up to 5 bars, it is necessary to schedule a pressure regulator
calibrated on 5 bars.
Check and if necessary scale the water and steam intake system
If the flow remain insufficient, contact the technical department.
WEEKLY PROGRAMMING
The oven has not
started as scheduled
Check if the regulator has been de-energized (power blackout) within the hour before the
programmed baking start time.
Open the program and control that parameters have well been registered.
Check on the summary screen that the program which has not started was properly activated
.
The oven has not
stopped between
both daily programs
Check on the summary screen that both daily time bands are well spaced by 1 hour
minimum
.
Unintended starting
of the oven
Check on the summary screen that no automatic start program was activated for the time and
day of the unintended starting of the oven
If the problem persists, contact the technical department.
To Next Page
Loading...
