00085615.DOC, Version 1.0
23/28
OPERATION
After you connected the spot to the mains, the LED ML-56 COB PCL 100W starts running.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP, DOWN.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.
Stand-alone mode
In the stand-alone mode, you can do without a controller. Disconnect the EUROLITE LED ML-56 COB PCL
100W from the controller and call the internal program. Please refer to the instructions under Control Board.
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear of the LED ML-56 COB PCL 100W you can find an XLR-jack (DMX Out) and an XLR-plug (DMX
In), which can be used for connecting several devices.
Choose the device which is to control the effects. Set the desired Master-mode on the master-device. This
device then works as master-device and controls all other slave-devices, which are to be connected to the
master-device via a DMX cable. Connect the DMX out connectors with the DMX input plug of the next
device.
Set the Slave-mode on every slave-device. Please refer to the instructions under Control Board.
To Next Page
Loading...
Need help?
General
