1. Remove one of the two sealing caps
(Figure 20, pos. 1 or pos. 2).
2. Drain the water from the indoor unit.
3. Replace the removed sealing cap.
4. Make sure two screw caps are mounted on
the indoor unit.
5. Hook the indoor unit on the outdoor unit
for easy transport (Figure 21).
Figure 20.
Figure 21.
Installaon
WARNING
• Do not put the power plug into the wall socket before the device is correctly
mounted. Do not use an extension cable; this can cause overheang and re.
If using an extension cable is unavoidable, make sure it is undamaged and
earthed. Use an extension cable with a minimum power of 500 Wa. Always
unwind the extension cable completely to prevent overheang.
25
To Next Page
Loading...
