8
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Getting Started
Unpacking
• Carton: This product has been packaged to protect it against transportation
damage. Unpack the appliance and keep the original packaging carton
and materials in a safe place. It will help prevent any damage if the product
needs to be transported in the future, and you can use it to store the
appliance when it is not in use. In the event it is to be disposed of, please
recycle all packaging materials where possible.
• Plastic wrapping can be a suffocation hazard for babies and young
children, so ensure all packaging materials are out of their reach and
disposed of safely.
• Cord: Unwind the cord to its full length and inspect the cord and the plug
for damage. Do not use the heater if the appliance or its cord has been
damaged or is not working properly. In case of damage, contact our after
sales support centre for advice on examination, repair or return of the
damaged product.
• Documentation: Make sure you have read and understood all instructions
and warnings in this manual. Refer to the Product Overview, page 7, to
familiarise yourself with the product and identify all parts. Pay particular
attention to the safety instructions on the previous pages.
• Feet: The heater is packaged with the feet unattached. You must attach
them before turning on the heater.
Feet installation
• Put a soft covering on a table or benchtop and carefully lay the heater on top
with the bottom end at the edge of the table.
• Take the four feet out of the plastic bag and connect them to the underside
of the appliance. Insert the feet into their respective spaces at the
underside of the heater and turn to secure, as pictured below:
• Turn the heater in an upright position after the feet are properly fitted.
To Next Page
Loading...