3
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Important Safety Instructions
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
Read this manual thoroughly before first use, even if you are familiar with this
type of product. The safety precautions enclosed herein reduce the risk of fire,
electric shock and injury when correctly adhered to. Make sure you understand all
instructions and warnings. Keep the manual in a safe place for future reference,
along with any warranty information, your purchase receipt and packaging. If you
sell or transfer ownership of this product, please pass on these instructions to the
new owner.
Always follow basic safety precautions and accident prevention measures
when using an electrical appliance, including the following:
Electrical safety and cord handling
• Voltage: Before plugging in the heater, make sure your outlet voltage and
frequency correspond to the voltage stated on the appliance rating label.
• Electrical outlet / circuit: Always plug this heater into a separate wall outlet
socket that must be properly earthed. To ensure you do not overload the
circuit, do not operate another high-wattage product on the same circuit.
• Connection: To insert the plug, grasp it firmly and guide it into the outlet.
• WARNING: No extension cord: Do not use this heater with an extension cord
as this may overheat and cause a risk of fire. Do not use a plug adaptor.
• Protect the power cord:
– Do not operate the heater with the cord coiled up; always fully unwind.
– Do not twist or kink the cord or let it touch heated surfaces.
– Do not put any stress on the cord where it connects to the product.
– Never carry the heater by the cord.
– Arrange the cord away from any traffic areas so no one will trip over it.
– Do not run the cord under carpeting or cover it with rugs, runners, etc.
– Do not wrap the power cord around the heater when it may still be warm.
• WARNING: To reduce the risk of fire, electric shock or injury:
– Never touch the heater with wet or damp hands or feet.
– Do not use the heater if any part of it has become wet. Immediately call a
qualified service technician to inspect the heater and replace any part of the
electrical system that has got wet.
– Never spill liquid into the heater; never immerse the cord, plug or any part of
the appliance in water or other liquids.
• WARNING: Damage: Do not pick up or operate the appliance if the power
supply cord, plug or housing is damaged, after it malfunctions, or has been
dropped or damaged in any manner. Check the power cord regularly for visible
damage. If it is damaged, it must be replaced by the manufacturer or authorised
service agent in order to avoid a hazard. Contact our after sales support centre.
To Next Page
Loading...