6
3. INSTALLATION
To install the cooktop, cut out a rectangular opening in the count er as
shown in the drawing and table below. Also ensure that you have a
minim um of 10mm (3/8”) of space in the front of the unit, between the r ims
and front your counter for ventilation.
Apply the gasket only along the front r im and on both sides. Do not put this
gasket on the rim in the back. This gasket will prevent most of the spills from
entering the cabinet below and will keep the unit in place. Once the gasket is
installed, place the cooktop in the opening, and lay it on
the rim. Do this
carefully — do not drop the unit into the cutout. Make sure that the unit is
sitting properly on its rim all-round the perimeter.
Steps of Installation of the Hob:
1.Take out the screws which connect the installation board and Hob
and take away th e installation board.
2.Fix the installation board to the installation deskt op with the screws
provided in the packaging. As indicated below (graphics).
3.The power line must be lined to th e adaptable electricity supply by
professionals.
4.Put the Hob in the sink carefully
.
5.Fix the Hob to the in stallation sink with the screws originally used
for fixing the installation board.
To Next Page
Loading...