Association group_1 is default to associate with the primary controller (Gateway/Hub/Controller) for ZW31 Status
change report, 1. ZW31 will trigger AUTO report function if the Switch status had been changed.
Association group_2:basic set command
When the output of the ZW31 is changed, The ZW31 will automatically send out a related basic set command.
Restoring Factory Defaults
ZW31 is removed from the network and will be restored to the factory setting
All Configuration Parameters values and Association information will be restored to factory default settings and
excluded from the network. Remark : All the setting and data will be permanently deleted.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
File Downloads
User Manual
EVA LOGIK Smart Dimmer Switch, S2 In-wall Smart Dimmer Switch
Download [optimized]
Download
Related Manuals
1. EVA LOGIK Z-Wave Smart Plug Instruction Manual Z-Wave Smart Plug Installation Manual Z-Wave Network
Configuration ZW39 Z-Wave...
2. MONOPRICE Z-Wave Plus Smart In-Wall Dimmer Switch User Manual MONOPRICE Z-Wave Plus Smart In-Wall
Dimmer Switch User Manual SAFETY...
3. Z-Wave Plus Remote Dimmer Switch Instructions Instruction Bulletin GDE7796300 SQR50101**Z Z-WaveTM Plus
Remote Dimmer Switch **...
4. EcoDim Smart LED dimmer Z-Wave 0-200W User Manual USER MANUAL Smart LED dimmer Z-Wave 0-200W Eco-
Dim.07 Z-Wave Please...
5. Minoston Smart Dimmer Switch User Manual User Manual Minoston Smart Dimmer Switch MS11Z Smart Dimmer
Switch...
6. Minoston Smart Dimmer Toggle Switch User Manual User Manual Minoston Smart Dimmer Toggle Switch Federal
Communications Commission...
To Previous Page
Loading...