Evak DPC-10 - Fault Display Codes; EEEE Fault; FFFF Fault; EEFF Fault

6).Restore to default value setting or not
Restore to default value settings (show code dF-y)
»
Press to adjust the value to dF-y
Press once and restore to default value (Show code ----)
7).After finishing above settings, LCD screen display “loAd” or “ ----”
3 seconds later, go to the actual pressure status display automati-
cally .
Not restore to default value settings (show code dF-n)
»
Press to set the value to dF-n
Press once then all settings are stored. (Show code loAd)
Pressure controller display “EEEE”
It means the failure of pressure
sensor.
Pressure controller display “FFFF”
It means the failure of temperature
sensor.
Pressure controller display “EEFF”
It means the failure of pressure and
temperature sensor.
b).FFFF
c).EEFF
a).EEEE
10.Fault Display
18