EVAPCO LS Series - Accessory Location Checklist

15
LS Series Coolers and Condensers
Accessory Location C heckl i s t
Accessories can ship in a variety of locations depending on the type of accessory, the size of the unit and the accessories
purchased with the unit. See Table 11 for a guide to accessory location.
Table 11 – Unit Accessory Shipping Location
Unit Accessories Shipping Location
Aluminum Ladder Shipping Location is Unit and Accessory Dependent
- If Space is Available: Strapped Inside Unit Basin
- If No Space is Available: Shipped Separately on Truck Bed
Discharge Attenuation Shipping Location is Unit Dependent
-1.2m Wide Units: Shipped Separately on Truck Bed
-2.4m Wide Units and Larger: Mounted Loosely Bolted on Basin or Coil Casing
Discharge Hood with Dampers
Shipping Location is Unit Dependent
-1.2m Wide Units: Shipped Separately on Truck Bed
-2.4m Wide Units and Larger: Mounted Loosely Bolted on Basin or Coil Casing
Electric Basin Heater
Shipping Location is Unit Dependent
- End Mounted Heater: Installed in Unit Basin
- Side Mounted Heater: Strapped Inside Unit Basin
Electric Basin Heater Control Panel
Shipping Location is Dependent on Control Panel Size
- If Space is Available: Mounted on Unit Basin
- If No Space is Available: Boxed, Wrapped and Wire Tied Inside Unit Basin
Electric Basin Heater Low Water Cutout Shipped in Rigging Box Strapped Inside Unit Basin
Electric Basin Heater Thermostat
Shipping Location is Unit Dependent
- End Mounted Thermostat: Mounted on Unit Basin
- Side Mounted Thermostat: Shipped in Rigging Box
Electronic Water Level Control Probes Mounted in PVC standpipe
Electronic Water Level Control
PVC Standpipe Strapped Inside Unit Basin
Factory Mounted Crossover Piping
Welded to Coil Connections
Fan Screens (If not mounted)
Shipping Location is Unit and Accessory Dependent
- If Space is Available: Strapped Inside Unit Basin
- If No Space is Available: Crated and Shipped Separately on Truck Bed
Hot Water or Steam Coil
Installed in Unit Basin
Inlet Attenuation
Shipped as a Separate Section
Motor (If not mounted)
Installed In Unit Basin
Remote Sump Trash Screen
Installed In Unit Basin
Rigging Hardware
Shipped in Rigging Box Strapped Inside Unit Basin
Safety Cage
Attached to the Ladder
Sealer Tape Shipped in Rigging Box Strapped Inside Unit Basin
Sump Sweeper Piping with and without
High Flow Eductors
Installed in Unit Basin
Vibration Switch Mounted in Fan Section