17
ST
EP 7
Removing and Installing the Battery
DISC BRAKES
You can prevent brake squeal on a new bike by properly “bedding in” the brake pads.
It is also important to do this when brake pads are replaced.
1. Select an area in which to ride that allows you to reach a moderate speed safely.
2. Accelerate to a moderate speed and apply the brakes evenly, slowing the bike
to a walking pace. Do NOT come to a complete stop. Repeat this acceleration
andbraking sequence 20 times. Braking power will increase during this process.
3. Next, accelerate to a slightly higher speed and apply the brakes, slowing to a
walking pace. Again, do not come to a complete stop. Repeat this sequence 10
times.
4. Allow the brakes to fully cool before riding again.
quest_manual_final_single.indd 14 09/06/2017 19:55
1. At the forward area of the
basket is the battery lock.
Insert a key and turn to unlock.
2. Grasp the battery and slide rearward.
Installation is the reverse of removal.
Your Compass is equipped with a
parking brake for both the front and
rear. Squeeze the brake lever and pull
the black tab in to set either brake.
Squeeze the brake lever to release.
EVELO.COM
To Next Page
Loading...
