4
Installation
· Do not connect the fireplace to the power supply until properly fixed to the wall and the
instructions read fully.
· Always ensure the area to be drilled is free from hidden electrical wires, water and gas pipes.
· The minimum distances must be observed
as shown in the diagrams below.
· For installation of the fireplace, care must be taken not to damage concealed cables.
· Please be careful while drilling holes.
· This fireplace is designed to be permanently fixed to a wall. Ensure the wall is sufficiently
strong enough to hold the weight of the fireplace. Brick or breeze block walls are ideal. If
positioning on plasterboard wall, it must be fixed to timber batons. If you are not sure if the
wall is stable enough, then consult a hardware expert. The wall bracket must be fixed
horizontally and the cable routed to the bottom right of the fireplace.
· A height of 2 feet from bottom of fireplace to floor is recommended for optimum viewing of
fuel bedsee Fig.1 for recommend fixing dimensions.
· Keep top of fireplace at least 3 feet away from ceiling or other objects for optimum heat
ventilation.
· For optimum viewing, mark the top four screws fixing positions on wall in accordance with the
recommend fixing dimensions- see Fig.2.Drill holes with a six drill bit.
· Fix the wall bracket using that the plugs and screws provided .
· Carefully lift the fireplace ensuring that the top rear ledge of fireplace engages with the wall
bracket (see Fig.2 in circle) and is sitting centrally.
· Gently bring the fireplace level with the wall.
To Next Page
Loading...