6
Remote Operation
· The standby switch located at the top right hand side of the fireplace must be switch on
first.
· Insert 2 x 1.5V AAA type new batteries (not included) into the battery compartment of
Remote Control, ensure they are inserted with the correct polarity. Close the battery
compartment cover securely.
· It takes some time for the receiver to respond to the transmitter. Do not press the buttons
on the Remote Control more than once within two seconds, for the fireplace to operate
normally.
· Press the on/off button once to turn on the fireplace with flame effect.
· Press the low button once for low heat setting; press twice to switch off the heat
completely.
· Press the high button once for high heat setting; press twice to switch off the heat
completely.
· Press the dimmer button to operate the dimmer mode, repeated pressing will increase and
lower the brightness of the flame effect.
Safety Cut-Off
· This fireplace is equipped with safety cut-off feature, which will operate if the fireplace
overheats (e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT
automatically reset, and will need to be turned ON manually.
· To reset the Fireplace, disconnect the fireplace from the power port for at least 15 minutes.
Reconnect to the power port and switch on the fireplace.
Troubleshooting
· Check if the unit is plugged in the power port
· Check if the unit is in Standby mode. Turn the
unit ON.
· Check if heat is turned OFF.
· Check for safety cut-off operation.
· Check if the unit is plugged in the power port
· Check if the unit is in Standby mode. Turn the
unit ON.
· Check if the bulbs need replacement.
To Next Page
Loading...