Evenflo Gold Revolve 360 - Page 79

79
LATCH/UAS (Rear-Facing and Forward-Facing)
Installing LATCH/UAS
8. Push Base against vehicle seat
back. Tension LATCH/UAS Strap by
pulling on loop until snug, making
sure not to overtighten.
10. Apply pressure to fully close the
LockStrong™. The lock indicator will
turn GREEN when fully closed.
NOTE: If belt tensioner does not fully
close (lock indicator still RED), open
the LockStrong™ and try loosening
the LATCH/UAS strap slightly.
2
Tighten Aprete
1
4
Instalación con conectores inferiores
Lower Connector Installation
Open Abre
Close Cierre
Attach
Acople
25809061 10/20
3
Vehicle Belt Installation
Instalación con cinturón del vehículo
Open Abre
Route Ruta
Close and lock
3
Or O
4
2
1
Tighten lap belt Cinturón para regazo
Tighten lap/ shoulder belt Apreta cinturón para regazo y hombro
25809059 10/20
Cierre y bloquear
9. After tightening LATCH/UAS,
secure excess strap under the
LockStrong™.