60
Lap/Shoulder Belt (Rear-Facing and Forward-Facing)
Installing Lap/Shoulder Belt (Preferred Method)
9. Grab Base near belt path as shown
and pull side to side and front to back
to make sure Base is installed tightly.
Base should not move more than 2.5
cm (1 in) side to side or front to back at
the Belt Path on the Car Seat.
If Base moves more than 2.5 cm
(1 in), open LockStrong, tension
vehicle belt a little more, and try again.
If Base still moves too much, you may
need to try a different vehicle seat
location, installation method, or both.
10. Lock the seat belt. In most vehicles,
you can switch your shoulder belt
retractor into locking mode by pulling
out shoulder belt all the way and
letting it rewind into the retractor. Pull
on shoulder belt to make sure it is
locking.
To Next Page
Loading...
