93
Booster Mode (Forward-Facing Only)
Installing the Booster
8. Apply pressure to fully close the
LockStrong. The lock indicator will
turn GREEN when fully closed.
NOTE: If belt tensioner does not
fully close (lock indicator still RED),
open the LockStrong and try
loosening the LATCH/UAS strap
slightly.
6. Push Base against vehicle seat
back. Tension LATCH/UAS Strap
by pulling on loop until snug,
making sure not to overtighten.
7. After tightening LATCH/UAS,
secure excess strap under the
LockStrong.
2
Tighten
Aprete
1
4
Instalación con conectores inferiores
Lower Connector Installation
Open
Abre
Close
Cierre
Attach
Acople
25809061
10/20
3
Vehicle Belt Installation
Instalación con cinturón del vehículo
Open
Abre
Route
Ruta
Close
and lock
3
Or
O
4
2
1
Tighten
lap belt
Cinturón para
regazo
Tighten lap/
shoulder belt
Apreta cinturón
para regazo y
hombro
25809059 10/20
Cierre y
bloquear
To Next Page
Loading...
