Evenflo SHYFT RIDESHARE - Attaching Infant Car Seat

18
ATTACHING INFANT CAR SEAT
1. To attach infant car seat to
stroller wagon, lock brakes,
place canopy down at front
of wagon, and set up product
in Stroller Mode, as shown.
2. Unzip seatback flap on
parent-facing side. Flip
seatback flap toward center
of wagon.
NOTE: Infant car seat
icon can be located on
seatback flap.
3. Ensure child tray is
connected to center of
wagon (see pg. 12).
IMPORTANT: Child tray
MUST be installed to attach
Infant Car Seat to stroller
wagon.
• Only use Evenflo SafeMax™ or any version of the LiteMax™
infant car seats with this stroller. Other infant car seats or
carriers are not designed to fit the stroller frame and if used with
this stroller may result in serious injury to your child.
• Before using the infant car seat with this stroller, read all the
instructions provided with infant car seat and keep the instructions
stored properly for future use.
• DO NOT lift stroller by using the infant car seat handle when
installed on stroller.
• Parent’s handle MUST be in the longest position when using infant
car seat on stroller wagon.
• If unable to securely attach your infant car seat to this stroller,
remove the car seat and contact Evenflo ParentLink at
1-800-233-5921 (USA), 1-937-773-3971 (Canada), or
800-706-1200 (México).
• To avoid serious injury, make sure the infant car seat is securely
snapped onto the car seat mounts.
WARNING!
DEATH or SERIOUS
INJURY can occur.