9
ENGLISH
ASSEMBLING YOUR PRODUCT
ENGLISH
NOTE: To protect flooring, place a
protective covering (cardboard,
towel, small rug or blanket)
beneath the product during
assembly.
1. To attach all-terrain rear
wheels, push wheel onto rear
wheel assembly until it clicks
into place as shown. Repeat
on other side.
2. To attach rear axle assembly,
turn stroller wagon over so
rear tube is positioned as
shown.
Align the rear axle assembly
with rear tubes and push onto
tubes until an audible click is
heard.
Pull on rear axle assembly to
make sure both are securely
attached.
3. Locate front wheel assemblies.
To attach front wheel, line up
metal pin with hole in front
wheel mount and push onto
frame as shown until it clicks
into place.
Repeat process on other side
of frame. Pull on wheels to
make sure both are securely
attached.
Care must be taken when folding or unfolding stroller to prevent
finger injury to you or your child. Make sure child is not in the seat
or near the stroller when folding or unfolding.
CLICK!
To remove wheel, press tab on
back of wheel mount and pull.
CLICK!
CLICK!
WARNING!
DEATH or SERIOUS
INJURY can occur.
To Next Page
Loading...
