4. If done correctly, the display will read “BYPASS”. The LEDs above the left
and right footswitch will blink red.
5. Turn the encoder knob to the right until the display reads “UTILITY”.
6. Push the encoder knob down. The display will read “CATCHUP”.
7. Turn the encoder knob to the right until the display reads “SER#”.
8. Push the encoder knob down. If the display reads the serial number shown on
the back of the unit, the procedure was done correctly.
9. To exit bypass mode, repeat step 3, or cycle power in the unit by unplugging
the power supply from the back of the unit and plugging it back in.
To Previous Page
Loading...
