Eventide Space User Manual

`
User Guide
WARNINGS
Use only with supplied power supply.
Avoid spilling liquids onto/into the unit.
Do not expose to excessive heat or moisture.
Do not open – there are no user serviceable parts inside.
This equipment has been tested and found to comply with the limits for a Class B digital
device pursuant to Part 15 of FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Complete User Guide Part #159029 Rev C
Contents Part #142335 Rev C
Eventide and Harmonizer are registered trademarks of Eventide Inc. ©2014 Eventide Inc.

Eventide Space Specifications

Analog I/O

input impedance (mono)	500k ohms
input impedance (stereo)	1 Meg
output impedance	470 ohms
recommended load impedance	10k ohms or greater

Connectors

input 1	¼ inch mono phone jack
input 2	¼ inch mono phone jack
output 1	¼ inch mono phone jack
output 2	¼ inch mono phone jack
expression pedal	¼ inch mono phone jack
aux switch	¼ inch stereo phone jack
USB	Type B Socket
AC adaptor jack	5mm Barrel w/2.5mm Pin Polarity: Pin is (+) Barrel (-)
MIDI In	Five pin DIN (Female)
MIDI Out/Thru	Five pin DIN (Female)

Power Supply

voltage	9 VDC
current	500 ma
tip polarity	hot (+)

Weight and Dimensions

height (english)	4.8 inches
width (english)	7.5 inches
depth (english)	2.12 inches
height (metric)	122 mm
width (metric)	190 mm
depth (metric)	54 mm
weight (english)	2.15 lbs
weight (metric)	1 kg