Space User Guide Saving Presets
31
Note: The cursor will “wrap around the display.” Pressing the Left Footswitch will move to
the left by one character at a time until it gets to the first character, then it will jump to the
Preset Number field. Pressing the Left Footswitch again will jump to the last character.
Note: A phantom space is always present at the end of the name to allow characters to be
added past the end. This cannot be deleted but will be removed on exit.
Organizing Your Presets
When you save a Preset, you should consider when and how it will be used. For example, if
you have a pair of Presets that you plan to use together in the same song – one for the verse,
one for the chorus – placing them in sequential Preset numbers will let you quickly switch
from one to the other.
Loading a Preset takes two or more taps. Once tap of either the Middle or Right Footswitch
to cue the new Preset and tapping the Left Footswitch to load it.
Note: When saving to a location other than the active slot, the saved Preset location becomes
the active slot. In other words, if Preset #1 is currently active and, after changing the
parameters to get a new sound, you decide to save the new sound to in Preset #10, Preset
#10 becomes the active Preset.
To Next Page
Loading...
