User Guide Dumping Presets and System Settings
Dumping (Backing-up) Presets and System
Settings
The currently loaded effect, your stored Presets and your system settings can be dumped to a
MIDI device or to a computer using the MIDI’s SysEx facility. SysEx dump is a MIDI System
Exclusive Message that can be sent from and recorded by a MIDI sequencer or
computer. ’s Presets and System Settings can then be restored at a later time. This is a
useful way to backup saved settings or to reconfigure the unit as it was on your previous
project. The process takes a few seconds.
To Dump Presets &/or System Settings:
1) Press and hold the Encoder and Right Footswitch simultaneously for a few
seconds to enter System Mode. Release the Encoder.
2) Turn the Encoder until [MIDI] is displayed.
3) Momentarily press the Encoder.
4) Turn the Encoder until [DUMP] is displayed.
5) Momentarily press the Encoder.
6) Turn the Encoder to select [ALL], [CURRENT], [PRESETS] or [SYSTEM].
7) Wait until dump is complete.
8) Press and hold the Encoder and Right Footswitch simultaneously for a few
seconds to exit System Mode.
Note: If [CURRENT] is selected only the currently loaded Preset is dumped. If [PRESETS] is
selected, the currently selected range of Presets are dumped. If you have not limited the
Preset Range in System Mode, all 100 Presets will be saved. If ALL is selected all Presets and
System settings are dumped. If SYSTEM is selected, only System settings are dumped.
Restoring Presets and System Setting
Presets and System settings are restored via MIDI’s SysEx facility. must be set to the
desired SysEx ID number (from 1 to 16).
To set the MIDI SysEx ID number (factory default is 1):
1) Press and hold the Encoder and Right Footswitch simultaneously for a few
seconds to enter System Mode. Release the Encoder.
2) Turn the Encoder until [MIDI] is displayed.
3) Momentarily press the Encoder.
4) Turn the Encoder until [SYS ID] is displayed.
5) Momentarily press the Encoder.
6) Turn the Encoder to choose SysEx ID from [1] to [16].
7) Press and hold the Encoder and Right Footswitch simultaneously for a few
seconds to exit System Mode.
Note: The Eventide Update Utility (EUU) will only work if SysEx ID is set to 1
To Next Page
Loading...
