Space User Guide Setup
15
Note: Using MIDI Program Change to control Bypass - MIDI Program Change is typically used
to load a preset but it can also be programmed to directly control the unit’s BYPASS setting.
See the System Mode [MIDI] section for details.
Note: When connecting to a computer, we suggest that you use a dedicated audio
interface and to select the type of Bypass that works best for your application.
Note: has been carefully designed to not mess with your tone in any of the Bypass
settings.
Note: With ’s power turned off, the relays automatically Bypass the unit. This means
that if power should accidentally go down while you’re playing, your guitar signal will not
disappear. Of course, if power is down, you may have bigger problems.
Killdry – Send/Return Loop
If you’ve connected using an effect send/return loop (either your amp’s or a mixer’s),
’s Killdry feature can be enabled.
When Killdry is enabled, does not send any dry signal to the outputs; only the Effect.
Note that when Killdry is enabled, Bypassing will mute the Effect rather than Bypass it when
DSP Bypass is selected.
Killdry’s factory default is disabled. It can be enabled in the [BYPASS] menu of the System
Mode. Here’s how:
1) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to enter System Mode.
2) Turn the Encoder until [BYPASS] is displayed.
3) Momentarily press the Encoder.
4) Turn the Encoder until [KILLDRY] is displayed.
5) Momentarily press the Encoder.
6) Turn the Encoder to select either [YES] or [NO].
7) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to exit System Mode.
Global Mix
The Mix Control sets the relative levels of the input signal (dry) and the effect (wet). The Mix
setting is always saved with each Preset. Often however, it can be useful to have the Mix
setting uniform for all of the Presets that you’re using. To do this, use the System GLOBAL
MIX command. When GLOBAL MIX is ON, the Mix setting that was saved with the Preset is
ignored and the current Mix setting (Mix Control Knob) is used for all Presets.
Turning GLOBAL MIX ON or OFF. The factory default is OFF.
1) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to enter System Mode.
2) Turn the Encoder until [GLOBAL] is displayed.
3) Momentarily press the Encoder.
4) Turn the Encoder until [MIX] is displayed.
5) Momentarily press the Encoder.
6) Turn the Encoder to select [ON] or [OFF].
7) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to exit System Mod
To Next Page
Loading...
