User Guide System Mode
System Mode
System Mode is used for settings that apply to the overall system such as the Bypass, Aux
Switch, MIDI, etc.
To Enter/Exit System Mode
Press and hold the Encoder and Right Footswitch simultaneously for a few seconds to enter
and exit the System Mode. Upon exit you’re returned to the previous mode, either Preset or
Play. Upon entering System Mode, you’re at the top-level menu selection. The Left and Right
Footswitch LEDs will flash RED continuously to remind you that you’re in this special mode.
The Middle Footswitch LED, the Edited LED and Tempo LED are always OFF in System Mode.
At the top-level, turn the Encoder to scroll the choices, [BYPASS], [AUX SWITCH], [MIDI],
[GLOBAL] and [UTILITY]. Press the Encoder to select one of these choices.
System Mode Navigation
General navigation of the System Mode menus/parameters is as follows:
1) Push the Encoder to step down into the menu tree.
2) Turn the Encoder to scroll through menu items or parameter selections or values.
3) Press the Middle Footswitch to step up the menu tree to upper level menu options.
For sub menus with two fields, press the Left or Right Footswitch to select the active field. The
LED above the Footswitch of the active field will be lit.
Hint: While the Middle Footswitch can always be used to step up the menu tree, for menu
items that are only one level deep, pressing the Encoder a second time will also step up to the
top level.
To Next Page
Loading...
