Space User Guide The Footswitches
30
grouping your Presets, you can get through a song or set without having to click through all
100 Presets. Remember, when saving Presets, group them to best suit your needs.
The factory default sets the number of active Presets to 100 (Preset#1 to Preset#100). To
limit the number of active Presets:
1) Press and hold the Encoder and Right Footswitch simultaneously for a few
seconds to enter System Mode. Release the Encoder.
2) Turn the Encoder until [UTILITY] is displayed.
3) Momentarily press the Encoder.
4) Turn the Encoder until [PRESET RANGE] is displayed.
5) Momentarily press the Encoder.
6) Press the Left Footswitch and turn the Encoder to set the lower limit.
7) Press the Right Footswitch and turn the Encoder to set the upper limit.
8) Press and hold the Encoder and Right Footswitch simultaneously for a few
seconds to exit System Mode
Saving Presets
To save a Preset:
1) Press and hold the Encoder for a few seconds. The current Preset# and 10
characters of the Preset Name are displayed. Release the Encoder. The “Edited” LED
flashes. The Preset # flashes if it is NOT the currently loaded Preset. If the currently
loaded Preset # is displayed, it is solidly lit.
2) Turn the Encoder to select the desired Preset#. The “Edited” LED flashes when the
currently displayed Preset# is not the active Preset#. When saving, all Preset
numbers are available even if you’ve limited the number of active Presets.
3) Press the Right Footswitch and the first character of the Preset name will flash.
Turning the Encoder will change this character. Preset names can have up to 16
characters. (The available character set is '0-9', 'A-Z', '*’, ‘+’, ‘-‘,’_’, and ’|’.)
4) Use the Left and Right Footswitches to traverse the display, selecting the character
to be edited by the Encoder. (The active character for editing is always flashing.)
Repeated pressing of the Right or Left Footswitch will traverse the name, one
character at a time, flashing the selected character. Press and hold Left Footswitch
to DELETE the current flashing character.
5) Press and hold Right Footswitch to INSERT a character before the currently flashing
character.
6) To save the Preset, press and hold the Encoder a second time. The Billboard
displays “SAVED.”
7) After a short time, the Save mode is exited.
8) To exit Save without saving, press and release the Encoder again without holding it
or press any Footswitch at any time. Upon exiting Save mode without saving, the
Billboard displays “NO SAVE.”
Note: You must press and HOLD the Encoder to save. If you press and release quickly, the
new Preset will not be saved. This is intentional. When you save a new Preset, you overwrite
the old Preset. is designed to assure that saving is a deliberate act. The Preset number
corresponding to the currently running Preset will flash as a warning that saving in this
location will overwrite the currently loaded Preset.
Note: Name changes affect the current Preset even if NOT Saved. This feature allows you to
rename a Preset without changing any of the Parameter values.
To Next Page
Loading...
