User Guide System Mode
45
[KNOB MODE] – Control Knob Mode (NORMAL, CATCHUP, LOCKED)
Press the Encoder to select. Turn the Encoder to select.
With CATCHUP selected, the Parameter Control Knobs must be turned to the position which
corresponds to their current parameter value before they become active. The Catchup feature
is a good way to prevent inadvertent or abrupt changes to your sound.
When LOCKED is selected, the Parameter Control Knobs are disabled.
Press the Middle Footswitch once to back-up one level to UTILITY menu.
Press the Middle Footswitch twice to go to the top level System menu.
[SPILL] – SpillOver Enable (1-5 SEC, OFF)
Press the Encoder to select. With SpillOver enabled the ‘tail’ of the previous Preset effect
‘spills’ over for the selected time when a new Preset is loaded. Spill default is 2 SEC. Turn the
encoder to OFF to disable the Spill function. When SpillOver is off, there will be an abrupt
change in the type of echoes.
Press the Middle Footswitch once to back-up one level to UTILITY menu.
Press the Middle Footswitch twice to go to the top level System menu.
[PRESET RANGE] – Select the range of Active Preset (1 - 100)
Press the Encoder to select. Press the Left Footswitch to select the lower limit and the Right
Footswitch to select the higher limit. Turn Encoder to set the lowest and the highest active
Preset. Only Active Presets are available for loading using the Footswitches. All Presets may
still be loaded using MIDI program change.
Press the Middle Footswitch once to back-up one level to UTILITY menu.
Press the Middle Footswitch twice to go to the top level System menu.
[PEDAL LOCK] – Expression Pedal Lock (ON, OFF)
Press the Encoder to select. Select ON to disable Expression Pedal programming.
Press the Middle Footswitch once to back-up one level to UTILITY menu.
Press the Middle Footswitch twice to go to the top level System menu.
[PEDAL CAL] – Expression Pedal Calibration (ON, OFF)
Press the encoder to select. When PEDAL CAL is ON, moving the connected expression pedal
from its minimum to its maximum will calibrate the pedal. Turn off to end calibration. Default
is OFF. See p.26 for more info on Pedal Calibration.
Press the Middle Footswitch once to back-up one level to UTILITY menu.
Press the Middle Footswitch twice to go to the top level System menu.
To Next Page
Loading...
