TOOLS REQUIRED
Scissors Phillips screwdriver
HARDWARE REQUIRED (NOT INCLUDED)
Screws (4)
Use and Care Guide
Dryer Duct to Wall Connector
Installation
1
SEPARATING THE
CONNECTOR PIECES
□ Separate the female wall
connector from the male duct
connector by pressing the two
buttons on the sides and pulling
the two pieces apart.
2
TRIMMING THE DUCT
□ Use scissors or tin snips to cut
the duct coming out of your wall
so that it is ush with the wall
surface.
3
SECURING THE CONNECTOR
TO THE WALL
□ Insert the female wall connector
into the duct, and secure the
connector to the wall with the
appropriate screws depending on
your wall material.
4
SECURING THE CONNECTOR
TO THE DUCT
□ Secure the end of the male duct
connector onto the exible duct
coming from your dryer by turning
the male duct connector counter-
clockwise until it grips the duct
rmly.
5
JOINING THE TWO
CONNECTOR PIECES
□ To complete the installation, push
the male duct connector into the
female wall connector until the
buttons pop back into place.
6
SEPARATING THE CONNECTORS
□ When access is needed to clean
and maintain the ductwork,
separate the connectors as in
step 1.
Important Information
This product can be used with aluminum foil or semi rigid aluminum ducts.
Warranty
WHAT IS COVERED
All merchandise is warranted to be free from defects in workmanship and material for one year from the date of purchase. This includes normal wear and
performance failure on items. The manufacturer will replace or repair at their option.
WHAT IS NOT COVERED
This warranty only covers normal wear and performance failure. It does not cover any malfunction, performance failure, or defect arising from the misuse,
abuse, neglect, or modication of the product. Any damage or malfunction inicted upon the product by the user or other external sources, or any failure to
comply with the warnings and instructions, is not covered.
For further assistance visit www.HomeDepot.com.
Item # 596-498
Model #EZCNHD
HOMEDEPOT.COM
To Next Page
Need help?
General
