Everbilt SW07501T - Pre-Installation; Application; Tools Required; Materials Required

4
Pre-Installation
APPLICATION
 This submersible sewage pump is designed for pumping sewage, effluent, wastewater or flooded water with up to 2 inch solids.
TOOLS REQUIRED
MATERIALS REQUIRED (NOT INCLUDED)
NOTE: Parts shown below not to scale.
SPECIFICATIONS
Power supply 115V, 60 HZ., 15 Amp Circuit
Liquid temp. range max.131°F (55°C)
Discharge size 2 in. FNPT
Sump basin Minimum 18 in. (460 mm) diameter, 30 in. (760 mm) depth
Switch on/off On: 4 in. (102 mm), Off: 2.5 in. (63.5 mm)
2 in. check
valve
2 in. 90°elbow
2 in. discharge
pipe
2 in.
adaptor
Phillips
Screwdriver
Flathead
Screwdriver
Hand
Hacksaw or
PVC Cutter
Safety goggles
Tape Measure
Thread Tape
Wrench