8
Charger
NOTE:
Wall outlet - Green (stand by)
Wall outlet and Hoverboard - Red
(charging)
Wall outlet and Hoverboard - Green
(charged)
1. Plug the charger plug into
wall outlet. The light on the
charger should be green.
Note: If green light (LED)
does not turn on, try a
different outlet.
2. Plug the charger into the charger
port on the EV2 Hoverboard. The
light on the charger should turn yellow
during charging. The light will turn
green again when charging is
complete.
Battery Power Level Indicators
• Solid Green: Battery power level is 15 to 100 percent.
• Flashing Red: Battery power level is 5 to 15 percent, recommend
charging.
• Run time: Up to 1-2 hours of continuous ride time. (Run time may
vary depending on riding conditions, rider weight, climate, and/or
proper maintenance.)
• The charger supplied with the EV2 should be regularly examined for
damage to the
cord, plug, enclosure and other parts. In the event of such damage,
the Hoverboard must not be charged until it has been repaired or
replaced.
• It has built-in overcharge protection to prevent battery from being
overcharged.
Note: If the charger gets warm during regular use, this is a normal
response and is no cause for concern.
(Note: Charger design may
vary from one shown)
Https://www.LikeSporting.com
To Next Page
Loading...