6
RIDING YOUR EV2 HOVERBOARD
CONTROLS AND DISPLAY
Ensure your seat attachment is fully assembled and correctly installed
onto your hoverboard with all straps and screws secured in place.
Ensure your hoverboard is properly maintained as well. Failure to do
so may result in serious bodily harm or death and damage to the unit.
Follow the steps below to begin riding your EV2 Hoverboard.
1. Turn on your hoverboard.
2. Sit comfortably in the hoverboard seat attachment.
2. Place your feet onto the foot rests.
3. Firmly grip both handle bars and slowly push them downward
simultaneously to move forward.
4. When riding, slowly pull both handle bars upwards simultaneously to
brake.
5. To reverse, slowly pull both handle bars upwards simultaneously.
6. To turn right, push the right handle bar down while holding the left
handle bar in neutral position.
7. To turn left, push the left handle bar down while holding the right
handle bar in neutral position.
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Take your device out of the box and place it flat on
a level surface. Press the power button once. Check the battery
LED indicator. The battery indicator light should be lit, indicating
the device is powered on.
Power Off: Press the power button once.
MAT SENSOR
There are four sensors under the foot mats on your EV2 Hoverboard.
When the user steps off the hoverboard mats, it will automatically initiate
self-calibration.
Https://www.LikeSporting.com
To Next Page
Loading...