Everdure OBES63 - Troubleshooting Mechanical Issues: Hinges & Knobs

Before putting on the knob ; be sure the knob segment and knob spring is set correctly
Mechanical component problems : Hinges & Knobs
Glass lid angle less than 90° / more
than 100°
IS THE LID HINGE COUNTERPART FIXED ?
FIX THE HINGE COUNTERPART.
IS IT STILL LESS 90° / MORE THAN 100° ?
NO
HINGE PROBLEMS
Oven door hinge noisy
KNOB PROBLEMS
REPLACE GASKET.
( KNOB GASKETS MUST BE SET PROPERLY ON
BOTH SIDES )
KNOB LOOSE
IF THE SPIRAL KNOB SPRING IS REMOVED,
ASSEMBLE A NEW KNOB RING.
KNOB GASKET GETTING OUT OF ITS
PLACE
knob spring
knob segment
knob ring
IF NOT OKEY ;
CHANGE THE KNOB GASKET
Knob gaskets must be controlled on both
sides - to set properly.
IF KNOB SPRING IS AVAILABLE,
CHANGE THE KNOB.
CHANGE OVEN DOOR HINGE
MODELS: OBES61
OBES62
OBES63
SERVICE MANUAL BUILT IN ELECTRIC OVENS
Page 8 of 23