6
To set the focus, loosen the Focus ring knob first, then turn the ring toward <∞> or <N> as
necessary. When the focus is obtained as desired, tighten the focus ring knob.
(5) Zoom Ring
Loosen the zoom ring knob, then you can adjust the viewing range. Turn the ring towards <W>
for WIDE or <T> for TELE as necessary. When the setting is finished, tighten the zoom ring
knob.
(6) Power input
Use the connector to connect with 12VDC/24VAC power adaptor.
(7) Video Output BNC Connector
Use the connector to connect with the video in connector of a monitor.
(8) DIP Switch and ALC/Iris adjuster
Use this for detail camera setting including AGC, Backlight Compensation, Flickerless, Iris.
Please see the detail in Camera Setting Section.
(9) Ground Pin
For monitor use. When setting up the camera, connect a monitor to this video output pin and to
the GROUND pin using alligator clip cables, then use the image displayed on the monitor, set the
surveillance angle.
To Next Page
Loading...
