Customer Service 1-888-707-
1880
Dyaco Canada Inc. 2021
Email: customerservice@dyaco.ca
TROUBLESHOOTING
How to enter factory settings to change from miles to kilometers
Remove the safety key. Press and hold the PROGRAM button and reinsert the safety key. Release
the PROGRAM button after reinserting the safety key. Press the ENTER button once to select
miles or km (0 is miles and 1 is KM). Press the speed ▲ / ▼button to change the values in each
menu. Roller diameter (60), speed (0.5mph to 12mph, or 1km to 18km), and incline 12. Stand
beside the treadmill and press the START button to start the calibration procedure. The treadmill
Error Messages and Troubleshooting for Digital-Control System Treadmills
Console showing E0 Safety Switch Malfunction
1. If safety key is placed
improperly?
2. Is safety key defective?
key
Console showing E1
Only in calibration mode
Missing speed signal
speed sensor is connected
speed sensor
2. Speed sensor is defective
speed sensor
Console showing E2
Over current protection
Treadmill overload, controller
protection is activated.
1. Check and make sure of
proper walking belt
alignment. Make sure of
periodic lubrication to
minimize belt resistance.
maintenance
2. Any roller bearing
damage?
Console showing E3 Incline Error
incline motor and controller
connected correctly and
properly.
mechanism being stock or
Replace
incline motor
3. Is VR connected properly
or with intermittence?
Replace
incline motor
Console showing E4 Improper motor input voltage
1. Motor is not connected
properly or even not
connected to the
properly
Console showing E5
Communication disconnected
between the console and the
controller or communication
1. check and make sure of
proper connection
between the console and
properly or
replace cables
Console showing E6 Controller malfunction
1. Controller component
failure (e.g. IGBT)
Console showing E7 Abnormal power input
1. check and make sure of
proper voltage input for the
To Next Page
Loading...
