15
Eversense 365 CGM System Quick Reference Guide
Once the sensor has been inserted by your health care provider and you have paired your
transmitter and the app, your sensor needs to be linked to your smart transmitter. This will start
the 24 hour Warm-Up Phase. There is no need to wear the smart transmitter during the
Warm-Up Phase. To link the sensor, your mobile device must be connected to the internet and
your transmitter must be charged, turned on, and paired with your mobile device.
When you first link the sensor, with the Tegaderm™ bandage over the insertion site, the incision
is likely in the center of the Tegaderm. This means the sensor is likely above the center of
the Tegaderm. The first time you link the sensor, do not use an adhesive patch on the smart
transmitter. When positioning the smart transmitter over the sensor, it should be slightly above the
center of the Tegaderm patch.
Tip: Your sensor may not be precisely perpendicular to the incision. If you find it dicult to get
a Good or Excellent signal in the Placement Guide, do not apply pressure. Do try slightly rotating
the smart transmitter over the sensor. Wait about 1 second for the Placement guide to refresh
between each adjustment to the smart transmitter’s position over the sensor.
For details on linking the sensor, please review Linking the Sensor in the Eversense 365 CGM
System User Guide.
Linking the Sensor and Smart Transmitter
To Next Page
Loading...
