8 Troubleshooting
70/ 106 e’line User Manual | © Eversys AG
8.2 Error messages
If the actions listed below fail to rectify the issue or other problems not listed here occur, contact your
local service organization.
# Info message Explanation / Corrective action Refer to
E-000
Bean hopper rear missing
Bean hopper removed during a process (e.g.
during cleaning: replace the bean hopper and
wait until cleaning is finished).
-
E-001
Bean hopper front missing
Bean hopper removed during a process (e.g.
during cleaning: replace the bean hopper and
wait until cleaning is finished).
-
E-010 Software too old.
Please start software update.
Contact service organization. -
E-011 Hydraulic unit not connected.
Water pump has been swit-
ched off.
Contact service organization. -
E-012 Milk unit not connected.
Water pump has been swit-
ched off.
Contact service organization. -
E-013 Brewing unit not connected. Contact service organization. -
E-014 Grinder unit not connected. Contact service organization. -
E-095 Software update running.
Please wait...
Contact service organization. -
E-097 Please set machine type Contact service organization. -
E-098 Please start software update Contact service organization. -
E-099 Communication Error.
Please turn the coffee
machine off, wait 10 s and
turn it on again.
Communication error.
Please turn the coffee machine off, wait 10 s and
turn it on again.
“5.2” on page 38
E-100 Pressure Sensor Always Zero Contact service organization. -
E-102
Steam Boiler Empty Timeout
- Switch the machine OFF, wait 10 sec. and turn it
back ON.
- If doesn’t work, contact service organization.
“5.2” on page 38
E-103 Timeout during steam boiler
filling.
Please check the water supply
and press "Continue".
- Switch the machine OFF, wait 10 sec. and turn it
back ON.
- If doesn’t work, contact service organization.
“5.2” on page 38
E-104
Timeout Steam Heating
- Switch the machine OFF, wait 10 sec. and turn it
back ON.
- If doesn’t work, contact service organization.
“5.2” on page 38
E-105 Steam boiler connector mis-
sing
Contact service organization. -
E-197 Please set machine type Contact service organization. -
E-198 Please start software update Contact service organization. -
E-199
Communication Error Steam
See E-099 on page 70.
-