Everus HGM408 - Kneading Dough

Kneading Dough
1）Make sure that the Chopping Blade is placed rst when putting the ingredients in the Bowl, so as to avoid the diculty
to assemble Chopping Blade.
2）The Bowl Lid should be in the right postion to avoid not working.
3）Do not process hard food materials, such as coee beans, ice cubes, etc. to avoid cracking Bowl and deformation blunt of
Chopping Blade;
4）Ingredient should not exceed the maximum calibration line of the Bowl, otherwise the crushing eect and life of the
product will be aected.
5）When there is ingredient sticking to the Chopping Blade and Bowl, please be sure to turn o the power, then take out
the food.
1
2
3
Place the Bowl on the Main Body, the angle between the handle and the
main body safety switch is about 55 degrees (before placing, make
sure that the Main Body is on a at desktop and it is not shaking)
Hold the handle of the Bowl and turn it clockwise into the Main Body.
When the "▼" on the Bowl is opposite to the Main Body “ ” or a "click" is
heard, it indicates that the Bowl has been rotated in the right position.The
product does not work if the Bowl is not in the right position
Put the Drive Shaft into the Bowl.
CAUTION
4