-2-
1. INTRODUCTION
This manual provides all safety information, operation
instruction, specifications and maintenance for the meter,
which is compact, handheld, and battery operated.
This instrument performs AC/DC voltage, AC Current,
Resistance, Audible Continuity, Diode and Temperature
measurements. It is a 3 5/6 digits, 6000 counts auto ranging
digital clamp multimeter.
DT201D digital clamp multimeter has been designed
according to EN61010-1 oncoming electronic measuring
instruments with an over voltage category (CAT III 600V
CAT II 1000V) and Pollution degree 2.
Warning
To avoid possible electric shock or personal injury, and to
avoid possible damage to the meter or to the equipment
under test, adhere to the following rules:
• Before using the meter inspect the case. Do not use the
meter if it is damaged or the case (or part of the case) is
removed. Look for cracks or missing plastic. Pay attention
to the insulation around the connectors.
• Inspect the test leads for damaged insulation or exposed
metal. Check the test leads for continuity.
• Do not apply more than the rated voltage, as marked on the
meter, between the terminals or between any terminal and
grounding.
• The rotary switch should be placed in the right position and
no any changeover of range shall be made during
measurement is conducted to prevent damage of the meter.
• When the meter working at an effective voltage over 60V in
DC or 30V rms in AC, special care should be taken for there
To Next Page
Loading...