2
English
Installation
TOP QUALITY PROTECTIONS
The B3 series comes equipped with the most comprehensive protection set possible, including Over Voltage
Protection (OVP), Under Voltage Protection (UVP), Over Power Protection (OPP), Short Circuit Protection (SCP),
Over Current Protection (OCP), and Over Temperature Protection (OTP). This product is also covered by an
exceptional 5-year warranty and EVGA’s legendary customer service and support.
SUPERIOR BUILD QUALITY
The B3 series is built to the highest standards, using Japanese capacitors and high quality brand-name
semiconductor components for the highest performance and reliability. The Ultra Quiet 130mm Long Life Sleeve
Bearing fan provides adequate cooling to allow near silent operation.
MODULAR DESIGN
Reduce clutter in the case, improve ambient temperatures with better airflow overall and provide a clean look to
any system. Modular PSU designs allow the user to disconnect the cables from the power supply side if they are
not needed for the specific configuration. This can help free up space inside the case and improve cable
management as well as airflow throughout the system.
ECO THERMAL CONTROL SYSTEM
The EVGA ECO Intelligent Thermal Control System provides silent operation at low loads, improved efficiency
and longer life span of the fan. Enabled by a simple switch directly on the power supply, the “No Fan Spin” feature
is ideal for users looking to reduce ambient noise overall. Save on energy costs and unnecessary fan usage with
the EVGA ECO Thermal Control System.
1. Remove the power supply from its packaging.
2. Use the screws provided with your case to install the power supply into your computer. NOTE: It is
recommended to install the power supply with the fan facing down. However, if your case places the power
supply at the bottom of the case and there are no ventilation holes available, it may be best to install the power
supply with the fan facing up for greater efficiency and reliability.
3. Connect the 24-Pin ATX cable to the PSU and the motherboard.
4. Connect the 4+4-Pin EPS12V cable to the motherboard.
450W / 550W / 650W / 750W / 850W BRONZE
Power Supply User Manual
1 2 3 4
To Next Page
Loading...
Need help?
General
