Need help?Do you have a question about the EVGA GTX 1080 Ti FTW3 HYBRID and is the answer not in the manual?
General| GPU Architecture | Pascal |
|---|---|
| CUDA Cores | 3584 |
| Base Clock | 1569 MHz |
| Boost Clock | 1683 MHz |
| Memory Size | 11 GB |
| Memory Type | GDDR5X |
| Memory Interface | 352-bit |
| Memory Bandwidth | 484 GB/s |
| TDP | 250 W |
| Interface | PCIe 3.0 x16 |
| Power Connectors | 2 x 8-pin |
| Recommended PSU | 600 W |
| DirectX | 12 |
| OpenGL | 4.5 |
| Maximum Resolution | 7680 x 4320 |
| Cooling Solution | Hybrid Cooling |
| Outputs | 3 x DisplayPort, 1 x HDMI, 1 x DVI-D |
| SLI Support | Yes, with HB Bridge |
Remove the 4 spring screws and 22 backplate screws. Disconnect LED connectors carefully.
Carefully remove the heatsink and fan, disconnecting wires. Twist thermal module to loosen.
Remove thermal grease from GPU using isopropyl alcohol and lint-free cloth.
Install the memory baseplate after removing protective tape.
Place the right backplate and tighten with 4 #8 screws.
Align and install the #5 Tube Bracket using #08 screws.
Install the #4 VRM heatsink and connect the fan power connector.
Install the pump/heatsink on the GPU and tighten with 4 #6 screws.
Connect LED cables and install the shroud, securing with #7 screws.
Fasten remaining backplate screws using #9 and #8 screws.
Fasten a bracket using one #8 screw and one #10 nut.
To Next Page