EVOCA Kalea Plus - Advanced Milk Parameters; Milk Parameter Settings

01-2018 5035 01 47
powDEr spEED
Sets the working speed of the motor-doser
to dene its ow rate.
powDEr DElay
An instant powder time delay can be set
so that it starts after the water has been
dispensed into the mixer (activation of the
pump/ solenoid valve).
stEp
The instant powder is dispensed at regular
intervals simultaneously with the water.
Set how many intervals are required to
dispense instant powder whilst the water is
being dispensed.
Set the intervals (steps) according to the
powder used, in order to obtain a high-qual-
ity and well-presented beverage.
DEcaffEiNatED coffEE cyclE
The instant powder is dispensed before the
water to improve the presentation of the
beverage.
Enabling this option is recommended for
instant coee.
aDvaNcED milk paramEtErs
start
DElay
Set a time delay for when to dispense the
milk, after the previous ingredient.
It can help the beverage be presented bet-
ter.
milk spEED
Sets the milk pump ow rate in cm3/s.
triggEr timE
When the dispensing starts, the milk pump
is activated at maximum speed for a set
time; this makes up for any pockets in the
milk circuit.
After this time, the pump speed is automati-
cally adjusted according to the set ow rate.
ENabliNg stEam
It is possible to enable/ disable the steam
dispensing function whilst the milk is being
dispensed.
The steam heats the milk in the milker noz-
zle.
If the function has been disabled, the milk
is not heated.
stEam DElay
Sets the time delay of the steam solenoid
valve opening so that it opens after the milk
pump has been activated.
stEam quEuE
Extends how long the steam is dispensed
for after the milk pump has been disabled.
Set when to disable the steam solenoid
valve after the milk pump has been disa-
bled.
ENabliNg air
The air solenoid valve can be enabled/
disabled whilst milk-based beverages are
being prepared.
For selections which require non-frothed
milk (e.g. hot milk), keep the solenoid valve
disabled.
air DElay
Sets the time delay of the air solenoid valve
so that it starts after the milk pump has
been activated.
air quEuE
The air solenoid valve remains active (for
a set time) after the milk pump has been
disabled.
NozzlE wasH waitiNg timE
Once the selection has been dispensed, a
small amount of water can be dispensed
into the milker nozzle to partially clean it.
Set when (after the selection has ended) to
dispense a small amount of water.
The amount of water used to partially wash
the nozzle, will nish in the cup.