38
RIBBON
• No ribbon in the printer.
• End of ribbon.
• The ribbon is not correctly fitted.
• The ribbon is torn.
• The ribbon is not recognized.
Check the condition of the ribbon in the printer.
If you have a print job in progress, this restarts
with a new card.
CARDS
• No cards in the card feeder.
Reload cards into the feeder – the process
starts again.
• Error loading cards.
Check the cards are loaded. For any other
problems, contact your Evolis reseller.
PRINTER AND LAMINATION MODULE READY
• The printer is ready to receive data.
• The lamination module is ready.
FILM
• No film in the lamination module.
• No more film.
• The film is not correctly fitted.
• The film is torn.
• The film is not recognized.
Check the condition of the film in the printer.
PROCESSING
• The printer is receiving data.
• Lamination in process.
LAMINATION MODULE DOOR
• The door of the lamination module is open.
Close the door. The lamination restarts.
MECHANICAL ERROR
• Card jammed in the lamination module.
• Mechanical component fault.
For more details, refer to page 46.
If the problem persists, contact your Evolis
reseller for assistance.
PRINTER COVER OPEN
• The printer cover is open.
Close the cover again. The printer restarts.
MECHANICAL ERROR
• Card jammed in the printer.
• Mechanical component fault.
Open the cover and hold down the control button
in order to eject the jammed card. For more
details, refer to page 46.
If the problem persists, contact your Evolis
reseller for assistance.
To Next Page
Loading...