50
Step 3 – Configuring the new print head
1 Power up the printer and check that it is properly connected to a computer on which the printer’s Evolis Suite Premium
®
is installed.
2 Under the Maintenance heading of the Evolis Print Center, click the Change Print Head tab.
3 Enter the PKN number of the print head kit under Enter PKN no., the number you noted down in step 2. Then click Confirm.
If the print head kit number is not entered correctly, printer malfunctions may occur and the warranty may be voided.
Step 4 – Cleaning the printer
On your printer’s control panel, the CLEANING light is lit: CLEANING
Cleaning is absolutely necessary after changing the print head. No print jobs can be run until the cleaning operation has finished.
Refer to chapter 3 – Maintenance to carry out cleaning.
Once cleaning has been carried out, your printer is once again ready to customize your cards.
NOTE
Wait for 2 minutes after cleaning before using your printer.
To Next Page
Loading...