EasyManua.ls Logo

Evolite EVO SPARK 600 - Remote Control Instruction

Evolite EVO SPARK 600
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HAZEBOX 1500 Manual Ver. 1.00 Page 11
9Warning and safety matters
1) Do not shoot more than 30 seconds each time. If the continuous shooting time is too long, the internal
temperature will rise sharply and cause permanent damage. After a single long-time shooting, the machines
should have a short pause to cool down.
2) The spark shooting will stop automatically after 30 seconds. If users need it to work again, please operate
the second channel again.
3) Max connection is 6 pieces via power connecting cables.
4) If there is no spark out with enough consumables, it is possible that the chain is stuck and please open the
side rubber and rotate the chain manually. Please contact after-sale service for help if it does not work.
5) After use the machines, do not immediately turn off the power. The heat-dissipating fan should take out the
internal air when the power is on. Otherwise, the internal heat is quickly transmitted to the surface of the
casing.
6) The operators should be 3-5 meters away from the cold spark machine.
7) Make sure the device is off before filling the consumables.
8) If the consumables are accidentally ignited, please use the sand to extinguish, do not use water.
9) Store consumables in a cool, dry, sealed environment.
10) Damage caused by improper use or human factors is not covered by the warranty.
11) The final interpretation right belongs to our company.
Display
content
Fault causes
Solution
E01
Heating failure
1. Check if the heat dissipation
plate is normal.
2. Replace the heat dissipation
plate or heating board.
E02
Heating is not controlled
Replace the heating board
E03
The internal temperature
of the machine is
extremely high
1. Check the cooling fan.
2. Stop heating and operating,
restart after 10 minutes.
E04
The air blower does not
work
3. Check if there is any foreign
object falling into the nozzle.
4. Replace the air blower motor.
E05
The sensor is faulty
1. Check sensor socket.
2. Replace the sensor.
Remote Control Instruction:

Related product manuals