3
The ‘new’ Pod is truly multi-functional. It can be run in several different ways for different
applications.
The Pod can be used:
• as a complete filter on a quarantine system
• as a pre-filter at the front of any new or existing system
• as a polisher at the end of any system
• off a mid water feed to aid mechanical filtration
• on a skimmer line as a mechanical filter
Remember that if you use the Pod solely as a mechanical filter, you will also get an
enhanced biological benefit in your system.
Eazy Pod Specifications and Flow Rates
Follow this manual carefully and your filter will provide a perfect environment for your fish.
One of the factors that can have a significant influence on our ponds is the turn over rate.
This is the time that it takes for the total water volume of the pond to pass through the filter
system once. On Eazy Pod ponds, where is used as the only filtration system, a total pond
volume turn over of every 2 hours is found to be best. Therefore if you have a 10,000 litre koi
pond, a flow rate of 5,000 litres per hour is ideal. On an ornamental pond of 20,000 litres,
10,000 litres per hour is the maximum flow rate and is ideal for that size and type of pond. The
lower the flow rate you use, the better the performance will be - as long as it does not result
in a turn over rate of more than two hours.
Max flow rate: 10,000 litres/hr 2,200 UK gallons/hr 2,640 US gallons/hr
Max koi pond size: 10,000 litres / 2,200 UK gallons / 2,666 US gallons
Max ornamental pond size (goldfish, shubumkins etc): 20,000 litres / 4,400 UK gallons / 5,333
US gallons
Kaldnes K1: 30 litres
Max feed rate: 100-120g per day
Recommended air pump: Airtech 40 or Airtech 40e
On opening your Eazy Pod you will find the
following;
30 ltr Kaldnes K1 Fig.2
4 inch rubber connector Fig.1.1
(Fit narrow end to outlet E)
Cleaning pipe Fig.3 Lid Fig.4
Aqua-Mania - www.aqua-mania.org - info@aqua-mania.org - +34 609934211
To Next Page
Loading...
