English
EVO010121MAN
WARNING:
• Ensure that the unit is switched off at the mains before you attempt to conduct
any type of maintenance on the UVC.
• Ensure the unit is installed in the recommended orientation.
• Fit the quartz sleeves and O-rings and switch on pump to check that unit is water
tight before fitting the bulb, bulb socket and end cap.
• Ensure that the end cap is tight before running the unit.
• After replacing bulbs or before tightening the end cap, make sure that the O-Rings
are in the correct position, and the bulb sockets are dry.
• If the electrical connections get wet, dry thoroughly before switching power on.
• This unit should only be installed by a qualified electrician.
INSTALLATION AND OPERATING MANUAL
Complete instructions for all models of evoUV
Evolution Aqua Ltd. Kellet Close - Wigan - Lancashire - United Kingdom - WN5 0LP
t +44 (0) 1942 216554 - e info@evolutionaqua.com - w www.evolutionaqua.com
Downloaded from http://www.watergardeningdirect.com
To Next Page
Need help?
General
