Evolution Aqua evoUV Series User Manual

INSTALLATION AND OPERATING MANUAL
Complete instructions for all models of evoUV
WARNING:
Evolution Aqua Ltd. - Evolution House - Kellet Close - Wigan - Lancashire - United Kingdom - WN5 0LP
t +44 (0) 1942 216554 - f +44 (0) 1942 418489 - e info@evolutionaqua.com - w www.evolutionaqua.com
15 25 30 55 75
UK/EU English
• Ensure that the unit is switched off at the mains before you attempt to conduct
any type of maintenance on the evoUV.
• Ensure the unit is installed in the recommended orientation, see page 9.
• Ensure that the end cap is tight before running the unit.
• After replacing bulbs or before tightening the end cap, make sure that the O-Rings
are in the correct position, and the bulb sockets are dry.
• If the electrical connections get wet, dry thoroughly before switching power on.
• Do not attempt to tamper or access the electrical connections inside the evoUV,
as doing so will invalidate the warranty.
EVO1291120171MAN
Affix serial number here

Evolution Aqua evoUV Series Specifications

General

Brand	Evolution Aqua
Model	evoUV Series
Category	Water Filtration Systems
Language	English

Summary

Important Safety Warnings

Pre-Maintenance Safety Checks

Electrical Connection Safety

Critical Safety Information

Operational Safety

Avoid UV exposure, do not run dry, protect from frost, supervise children.

Maintenance and Electrical Safety

Isolate power/water, disconnect appliances, dry wet connections, avoid tampering.

Power Supply Requirements

Use RCD (30mA), ensure earthing, correct fuse, avoid submersion, correct mounting.

Flow Rate and Sizing Guidelines

Optimal Flow Rate Recommendation

Model Selection by Pond Conditions

Guide to selecting correct evoUV model based on pond size and sunlight conditions.

Installing the Quartz Sleeve

Installing the UV Bulb

Positioning and Mounting the evoUV

Mounting Orientation and Space

Mounting Configurations and Plumbing

Gravity Fed Setup and Valves

Connecting to Pipework (Standard Models)

Hosetail Fittings and Flexible Hose

Instructions for connecting flexible hose using universal hosetails, including trimming.

Rigid Pipework Connections (Standard Models)

1½" Pressure Pipe Fittings

Options for connecting to 1½" pressure pipe using straight connectors or unions.

Connecting to Pipework (evo110 Model)

Rigid Pipework and Valves for evo110

Connecting evo110 with rigid pipe, solvent weld, and recommending ball valves for isolation.

evo110 Mounting and Plumbing Diagrams

evo110 Pump/Gravity Fed Setups

Electrical Connection and Safety

Qualified Electrician and Warranty

Emphasizes need for qualified electrician and warns against tampering with unit's electrical parts.

Supply Cable and Wiring Safety

RCD/RCCB and Isolation Requirements

Mandates RCD/RCCB protection and permanent wiring with isolation switch for safety.

UV Bulb Maintenance

Bulb Replacement Procedure

Step-by-step guide for safely removing and installing UV bulbs.

Quartz Sleeve Cleaning Importance

Quartz Sleeve Maintenance

Sleeve Removal and Cleaning

Instructions for removing, cleaning, and re-installing the quartz sleeve, including descaling.

Troubleshooting Leaks

Troubleshooting Common Issues

Pond Clarity and UV Function

Addresses unclear water, bulb not lit, and algae return issues, checking filtration and UV.

Leak Detection and Resolution

Product Guarantee Information

Guarantee Terms and Exclusions

Warranty Claims and Liability